First you need to decide on the place where the gas boiler will be installed. Although this apparatus is very reliable, the second outlet and the window to ventilate do not interfere. The Boiler is Installed in the So-Called Boiler Room-This is a Room Measoring Four to Eight Meters, At Least Two and Half Meters High and Built Using Non-Combustible Materials. In brick houses such a room is only plastered and painted. In the same wooden walls must be insulated with the same non-combustible material. Be sure to ground the boiler.
Budget option – buy gas convectors in Dnepropetrovsk, they are autonomous, with its own gas cylinder.
Features of the chimney
If there is a boiler, there should be a chimney. But it must be done after the purchase of the boiler, the models are many and each has its own characteristics of connection. The chimney must be installed properly to connect and use the boiler was safe.
Chimney
1) The diameter of the flue must coincide with the pipe that connects it to the boiler, then it will not be a problem to connect the gas appliance.
2) There must be an opening in the chimney so that it can be cleaned.
3) The shape of the tip of the chimney cone
4) The pipes through which the gas flows can be bent a maximum of 3 times.
The Chimney Can BE PLACED BOTH OUTSIDE and Inside the House. Each of these Options Has Pros and Cons.
IF the Chimney is located inSide the house, you need to insulate only a Small Part of the Chimney Coming Out on the Rooof, Becuse Most of It Will Be in the Heat in the Heat. But in the Case of A Breakage, It Will Begin to Leak Carbon Monoxide Inside the House. It Will Be Difficult to Carry Out Installation, and Repairs are not easy to doside.
IF Its Outside the House – You Will Need More Insulation, That Would Spend Almost All the Heat Insulation Pipe. In the Case of A Malfunction, There Will Be No Harm. It is Much Easier to Install, The Repairs Do Not Interfere.
Tips for Installation
1) Install, Not All of Course, Parts of the Chimney at Angle Not Exceding Thirty Degrees.
2) Never Make Branches Expeding One Meter in Length.
3) do not make Cross Sections.
4) do not use than 3 Elbows During Installation.
5) a hatch That allows you to clean the Chimney and Remove Condensation, It is Worth Installing Only in Those Places What the Pipe Turns.
6) if the Chimney Is Rectangular, It Must Be Square Rather than Elongated.
7) The Various Parts of the Chimney and All Sorts of Elements SHOULD Not Be Flexible.
8) Between The Components of the Chimney Can Not Be Ans, Otherwise It Will Not Be AirTight, In this Case Will Leak Carbon monoxide.
9) In Places Where The Chimney Intersects with the Roof, No Connection Shoups.
10) With your Own Hands You Need to Tightly Connect the Parts of the Chimney.
11) IF All Parts of the Chimney Connected Correctly, The Inside the Pipe Will Not Be Rumble.
12) Three to Six Meters Long Parts Should Be Horizontal.
13) if the pipe is attached where is no Heating, Such as an Outside Wall, The Chimney Must BELL Insulated.
